Download Trimble Outdoors CopernicusTM GPS Receiver GPS Receiver User Manual
Transcript
10.5 10 GPS Antennas and Cables The antenna that a receiver uses to collect satellite signals is sometimes called a GPS antenna to distinguish it from a radio antenna. Radio antennas are used for communication between receivers and external networks or systems. Note – Older models of antennas, such as Choke Ring or Micro-Centered L1/L2, have different power requirements. The Trimble R7 can adjust the antenna power output when you designate the appropriate antenna in GPS Configurator. For more information, see Antennas, page 35. Connect the receiver to its GPS antenna using the yellow TNC connector. Use a coaxial cable with a right-angle TNC plug at the antenna end. If the antenna cable length is … use … up to 15 meters (45 feet) RG-58 cable up to 30 meters (100 feet) RG-214 cable over 30 meters (100 feet) one of the following: • in-line amplifier • semi-rigid coaxial cable • a low-loss cable assembly Trimble R7/R8 GPS Receiver User Guide 97 Trimble R7 Operation Cables and Connectors