Download SUPER MICRO Computer AS1020S

AS1020S-8 User's Manual
Optimizing memory performance
If two processors are installed, it is better to stagger pairs of DIMMs across both
sets of CPU DIMM slots, e.g. first populate CPU1 slots 1A and 1B, then CPU2 slots
1A, and 1B, then the next two CPU1 slots, etc. This balances the load over both
CPUs to optimize performance.
Maximum memory (two CPUs): 32 GB for DDR333/266 and 16 GB for DDR400.
If only one CPU is installed, maximum supported memory is halved (16 GB for
DDR333/266 and 8 GB for DDR400).
Figure 5-4. Side and Top Views of DDR Installation
To Install:
Insert module vertically
and press down until it
snaps into place. The
release tabs should
close - if they do not
you should close them
yourself.
Note the notch in the slot and on the bottom of the DIMM.
These prevent the DIMM from being installed incorrectly.
To Remove:
Use your thumbs to
gently push each release tab outward to
release the DIMM from
the slot.
Populating Memory Banks for 64-bit Operation
CPU1
DIMM1A
CPU1
DIMM1B
CPU1
DIMM2A
CPU1
DIMM2B
CPU2
DIMM1A
CPU2
DIMM1B
CPU2
DIMM2A
X
X
X
X
X
X
X
X
X
X
X
X
5-8
CPU2
DIMM2B