Download Sun Microsystems 120 Server User Manual

log, viewing, 8-10
LOM device
configuration variables, 8-17
separating from the console on Serial A, 8-19
sharing Serial A between the console and the
LOM device, 8-20
upgrading firmware, 9-13
version number, 8-22
LOM device driver
configuring, C-1 to C-5
LOM interface
backwards compatibility, 9-13
escape sequence, 9-12
M
memory
installing additional memory, 4-9
Microsoft Windows
using Windows Hyperterminal, 6-11
N
Name Server, 7-5
network install server
creating, B-2
null modem cable, 6-7, 6-8
NVRAM chip
location on system board, 11-10
part number, 11-9
replacing, 11-9
customer-installable hardware and software
options, 1-5
PCI card
installing, 4-14
PCI cards
installing, 4-11
part numbers of available cards, 1-5
removing, 4-14
pinout
serial port, 6-5, 6-6
POST diagnostics, 10-2
power
DC supply and ground, 3-3
factor, 2-2
requirements, 2-2
switch, 7-7, 8-3
power consumption, 2-3
power LED, 10-12
power supply
fan, 8-23
monitoring PSU and fans, 8-8
power supply unit, 9-2
powering on, 7-7
problems
booting (OBP initialization aborts), 10-11
cannot set up a console connection to the
server, 10-10
displaying the lom> prompt or the Solaris
prompt, 10-11
getting to the LOM prompt, 10-11
setting up a console connection, 10-10
R
O
On/Standby switch, 7-7
OpenBoot diagnostics, 10-3
opening the system, 4-4
operating current, 2-2
operating environment, 1-9
output message
watch-net all diagnostic, 10-10
watch-net diagnostic, 10-10
P
part numbers
rackmounting, 1-10, 5-1 to 5-14
two-post relay rack, 5-12
rear fan subassembly
replacing, 11-19
relative humidity, 1-9
remote reset, 8-5
removal
CD-ROM, 4-9
CD-ROM drive, cable, and paddleboard, 11-7
DIMMs, 4-9
hard disk drives, 4-2, A-4
memory card reader, 11-5
NVRAM chip, 11-9
PCI card, 4-14
Index-3