Download Paxar 7410 Printer User Manual
Transcript
♦ If your network uses WEP encryption, you need to enable WEP and enter the appropriate WEP key(s). Contact your system manager to determine what information you need. ♦ If you are using TCP/IP and you do not have a DHCP server (see note below), you will need to manually assign a valid IP Address, Subnet Mask, and Gateway and then set the Boot Method to Static. 8. When you are done configuring, click OK. NOTE: If you are using DHCP on your network, the print server may have acquired valid IP settings at this point and no further configuration is necessary. This might work well if your DHCP server allows the print server to keep this address permanently, but in most cases, you should use a static address outside the range reserved for DHCP (See your DHCP server documentation for details). This is because when you configure your printer port, it goes to a static IP address. Your print server should be configured correctly at this point. 2-4 Configuring the 802.11b and IP Settings