Download Metz AF-1 Camera Flash User Manual
Transcript
707 47 0057.A2 Inh. 48AF-1C 18.09.2007 16:38 Uhr Seite 76 9 Special functions („Select“) Depending on the camera model or camera group, various special functions are available. For this purpose, data exchange must first occur between the flash unit and camera to access and set the special functions, for example by tapping the shutter release. Accessing the individual special functions is achieved with the button „Select“, that is to say, the buttons ( - ) or ( + ) must be pressed simultaneously. The accompanying special functions and settings desired are then carried out individually with the button ( - ) or ( + ). ☞ The setting must occur immediately after accessing the special functions since otherwise the flash unit automatically switches back to normal flash operation after a few seconds! 9.1 Motor zoom main reflector („Zoom“) ķ The motor zoom main reflector of the flash unit can illuminate lens angles from 24 mm (35 mm format): Thanks to the use of the integrated wide-angle diffuser , the illumination widens to 18 mm. Auto zoom The zoom position of the main reflector is automatically adjusted to the lens focal length when the flash unit is used with a camera that transmits the data related to the lens focal length. After the flash unit has been switched on, „Zoom“ and the current zoom position of the main reflector are shown in the display. Automatic adjustment occurs for lens focal lengths from 24 mm. If a focal length of less than 24 mm is used, „24“ flashes in the display as a warning that the shot cannot be completely lit. If so desired, the position of the main reflector can be manually adjusted in order to achieve particular lighting effects (such as spot effect etc.). Manual zoom mode The zoom position of the main reflector must be adjusted manually to the lens focal length when used with a camera that doesnít transmit the data related to 76 the lens focal length. In this case auto-zoom mode is not possible! After switching on the flash unit, „Zoom“ appears in the display and the current zoom position of the main reflector appears. Setting procedure • Press button combination „Select“ until „Zoom“ appears flashing next to the zoom position (mm). • Apply the setting desired with the buttons ( + ) and ( - ). The flashing display changes to „M.Zoom“ for manual zoom mode. The following zoom positions are possible for the main reflector: 24 - 28 - 35 - 50 - 70 - 85 - 105 mm (35 mm format). The setting takes effect immediately. After about 5 seconds the display stops flashing and the setting is saved automatically. ☞ When the camera transmits the lens focal length to the flash unit and a manual zoom setting results in the shot not being completely lit by the main reflector (for example, spot effect), the display of the zoom position of the main reflector flashes as a warning! Tip: If you do not necessarily need the full guide number and maximum flash range of the flash unit, you can leave the zoom reflector at the position for the shortest focal length of the zoom lens. This will provide full light coverage of the picture and eliminate the need to continually adjust it to the focal length of the lens. Example: You use a zoom lens with a focal length range of 35 mm to 105 mm. In this case, you set the position of the main reflector of the flash unit to 35 mm. Resetting to auto-zoom • Touch the shutter release to begin a data transfer between the flash unit and the camera. • Press the button combination „Select“ until „M.Zoom“ appears flashing next to the zoom position (mm).
This document in other languages
- français: Metz mecablitz 48 AF-1 digital Canon
- español: Metz mecablitz 48 AF-1 digital Canon
- Deutsch: Metz mecablitz 48 AF-1 digital Canon
- Nederlands: Metz mecablitz 48 AF-1 digital Canon
- italiano: Metz mecablitz 48 AF-1 digital Canon