Download Korg K61P Musical Instrument User Manual

Top and rear panels
23
24
25
26
27
12
1
2
3
4
13
5
6
7
8
9
10
11
21
22 18 19 20
17 16 15 14
1. Display
7. [MIDI CH/RIGHT] key
The display shows information such as scene numbers
and parameter values.
This key is used to specify the MIDI channel that the
selected trigger pad or foot pedal will transmit messages
on. When making settings for the Flam/Roll function,
this key specifies the value for the right edge of the X-Y
pad’s X-axis.
2. Encoder
In Play mode, holding down the [PROG. CHANGE/
WRITE/ALL PAD] key and turning the encoder transmits program changes. In Setting mode, it can be used
to set parameter values or select MIDI messages.
8. [SW TYPE/POLARITY] key
This key is used to select either “momentary” or “toggle”
type of behavior for the trigger pads and foot pedal.
This key is also used to invert the operation of the assignable knobs and the X-Y pad.
3. [SETTING/ENTER] key
In Play mode, pressing this key will switch to Setting
mode. In Setting mode, pressing this key will finalize
the settings and switch back to Play mode. This key is
also used when recalling a preloaded scene or to confirm a Scene Store operation.
9. [REL. VAL./LOWER] key
These keys are used to assign a parameter to the Xaxis or Y-axis of the X-Y pad.
This key is used to set the control change value that
will be sent when you remove your finger from the X-Y
pad, or when a trigger pad or foot pedal is released.
When adjusting the Flam/Roll function, this key specifies the value for the lower edge of the X-Y pad’s Yaxis.
5. [PEDAL] key
10. [VELOCITY/UPPER] key
This key is used when you want to make settings for a
connected pedal.
When a note number is assigned to a trigger pad or the
pedal, this key is used to select the velocity curve (only
for a trigger pad) or to set a fixed velocity value. If a
control change is assigned to a trigger pad or the pedal,
this parameter specifies the value of the control change
message that is transmitted when you press the pad or
pedal. When making settings for the Flam/Roll function, this key specifies the value for the upper edge of
the X-Y pad’s Y-axis.
4. [X]/[Y] keys
6. [NOTE/CC#/LEFT] key
This key is used to assign the MIDI messages that will
be transmitted by the trigger pads, pedal, assignable
knobs, and X-Y pad controllers. When making settings
for the Flam/Roll function, this key specifies the value
for the left edge of the X-Y pad’s X-axis.
6