Download Dell PC7024 Switch User Manual

Getting Started
Dolby Surround
Setup
Adjusting the speaker volume Z
To turn off the test tone
Press TEST TONE.
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This amplifier incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
z
You can use other buttons to adjust the center and
rear speaker level
Press CENTER LEVEL +/– or REAR LEVEL +/– in Step
5 above.
Note
GENRE
SOUND FIELD
ON/OFF
– SUB CH +
0
)
POSITION SWAP
=
— RMS —
DIRECTION
CLEAR
9
(
p
+
D. SKIP
P IN P
JUMP
P
r
— SOUND FIELD —
ON/OFF GENRE MODE
EQ/
TONE
BAND
DIGTAL
PROCESSING
CONTROL
SLOPE
DIRECT
TEST
TONE
— LEVEL —
+
+
REAR
CENTER
–
BASS
BOOST
DIGITAL
PROCESSING
CONTROL
ANT
TV/VTR
–
MASTER
VOL
MODE
Be sure to select “NORMAL SURROUND” or “ENHANCED
SURROUND” before outputting the test tone.
TEST TONE
CENTER
LEVEL +/–
DPC
MODE
MUTING
PROGRAMMABLE
REAR
LEVEL +/–
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2
Press GENRE repeatedly to select “DOLBY.”
3
Press MODE to select “NORMAL SURROUND”
or “ENHANCED SURROUND.”
4
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
5
From your listening position, use the digital
processing control buttons ( / ) to select the
parameter to be set and use the buttons ( / )
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust
Select
And set between
rear speaker
balance
REAR L R
L (left) and R (right)
rear speaker
level
REAR
–20.0dB and +10.0dB
(in 0.5 dB steps)
center speaker
level
CENTER
–20.0dB and +10.0dB
(in 0.5 dB steps)
subwoofer
level
SUB WOOFER –20.0dB and +10.0dB
(in 0.5 dB steps)
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
17EN