Download 3Com 4226T Switch User Manual

Transcript
DUA1730-0AAA04.book Page 18 Thursday, November 17, 2005 2:59 PM
18
CHAPTER 1: INTRODUCING THE SUPERSTACK 3 SWITCH 4200 SERIES
Default Settings
Table 5 shows the default settings for the Switch 4200 Family:
Table 5 Default Settings
Feature
Switch 4200 Family
Automatic IP Configuration
Enabled
Port Status
Enabled
Port Speed
All ports are auto-negotiated
Duplex Mode
All ports are auto-negotiated
Flow Control
■
Enabled in half duplex
■
Auto-negotiated in full duplex
Broadcast Storm Control
Enabled
Virtual LANs (VLANs)
All ports belong to the untagged Default VLAN
(VLAN 1) with 802.1Q learning operational
IP Multicast Filtering
Filtering enabled
Rapid Spanning Tree Protocol Enabled
Fast Start:
Enabled on all ports
RMON Alarm
Enabled
Smart Auto-Sensing
Enabled
LACP
(10/100/1000BASE-T ports and GBIC ports only)
Enabled
Quality of Service (QoS)
All ports prioritize NBX VoIP IP.
All ports set to “best effort” for all other traffic.
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
■
IP Address
■
Subnet Mask
■
Default Router