Download 3Com 4200G Switch User Manual

136
CHAPTER 16: MULTICAST CONFIGURATION GUIDE
Configuration Procedure
Product series
Software version
Hardware version
Switch 4500
Release V03.03.00
All versions
Switch 4210
Release V03.01.00
All versions
Configuring IP addresses for the interfaces of each device
Configure the IP address and subnet mask for each interface as per Figure 36. The
detailed configuration steps are omitted here.
Configuring Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP
on Ethernet 1/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface Ethernet 1/0/1
[RouterA-Ethernet1/0/1] igmp enable
[RouterA-Ethernet1/0/1] pim dm
[RouterA-Ethernet1/0/1] quit
[RouterA] interface Ethernet 1/0/2
[RouterA-Ethernet1/0/2] pim dm
[RouterA-Ethernet1/0/2] quit
Configuring Switch A
# Enable IGMP Snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping enable
Enable IGMP-Snooping ok.
# Create VLAN 100, assign Ethernet 1/0/1 through Ethernet 1/0/4 to VLAN 100,
and enable IGMP Snooping in this VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port Ethernet 1/0/1 to Ethernet 1/0/4
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] quit
Verifying the configuration
# View the multicast groups in VLAN 100 on Switch A.
<SwitchA> display igmp-snooping group vlan100
Total 1 IP Group(s).
Total 1 MAC Group(s).
Vlan(id):100.
Total 1 IP Group(s).
Total 1 MAC Group(s).
Router port(s):
Ethernet1/0/1
IP group(s):the following ip group(s) match to one mac group.
IP group address: 224.1.1.1
Host port(s):
Ethernet1/0/3
Ethernet1/0/4
MAC group(s):