Download Wolf C72SS Specifications
Transcript
PRECAUTIONS When scraping off heavy deposits of grease or oil from stainless steel equipment, never use ordinary steel scrapers. Particles of ordinary steel may become embedded in, or lodge on, the surface of the stainless steel. These will rust, causing unsightly stains and possible contamination of food. If it is necessary to scrape, use stainless steel, wood, plastic or rubber tools. TROUBLESHOOTING OVEN PROBLEM Uneven Baking Side to Side Uneven Baking Front to Rear Too Much Top / Bottom Heat Dried Out Products Excessive Meat Shrinkage Pilot Outage TOP BURNER OPERATION PROBLEM Excessive Valve Handle Temperatures / Sticking Top Burner Valves Poor Ignition Pilot and Burners Will Not Light CAUSES / CORRECTIONS Range not level side to side. Oven burner or bottom improperly installed. Wrong temperature setting for product. Warped pans. Flue not venting properly. Improper regulator setting. Contact service provider. Range not level front to back. Door not closing properly. Flue not venting properly. Improper regulator setting. Contact service provider. Build-up on side liners obstructing vent holes. Flue not venting properly. Too low temperature (Overcooking). Too long baking time. Thermostat calibration (Call for service). Roasting Temperature too high. Not enough moisture (Add pan of water). Call for service. CAUSES / CORRECTIONS Verify that oven door is closed. If door is closed properly, call for service. Improper ventilation. Call for service. Verify that main gas supply is turned on. Verify that burner assembly is properly installed. Call for service. FORM F35696 Rev. C (10-07) PRINTED IN THE U.S.A. - 10 -
This document in other languages
- français: Wolf C72SS