Download Regal 30 EXPRESS Owner`s manual

Equipment Operation
TYPICAL BERTH/SLEEPER SET-UP
Grasp the starboard backrest cushion and with a quick motion
pull up to release it from the retaining clip. Do the same with
The forward berth converts to a sleeper accommodating 2 the port cushion. The starboard backrest cushion forms the starboard berth. The port backrest cushion forms the port berth.
adults.To set-up the berth follow these steps:
See illustration 2.
1. First locate the 3 stainless steel bars. Insert the bars in the
3. After all cushions are installed make sure they are seaated
mold cut-outs using pole length as a placement guide.
properly before using the berth.
See illustration 1.
1 INSERT BARS IN SCALLOPED CUT-OUTS
CONVERSION COMPLETE
2
STBD. BACKREST
4. To disassemble the berth, remove each bar and store under
floor.
5. Make sure each backrest cushion is stored in its original position. Do not force the clips as they may damage the vinyl. The
clips should seat with light pressure only.
2. The forward berth backrest cushions fill in to form the
berth. The port and starboard backrests are held in place
with a clip.
33