Download Advent 300 Troubleshooting guide

Transcript
___
___
___
Loudspeaker connections
2
Make all speaker con
nections with the Power
switch Off.
When connecting
speaker wires to the
speaker terminals, make
certain that no wires or
splayed wire filaments
can short two speaker
terminals together, or a
speaker terminal to the
receiver’s chassis.
Do not connect the “hot”
(red) speaker terminals
directly together.
Should any of the above
conditions occur while
operating the Model 300,
damage may result
requiring service not
covered under the
warranty.
R
4
L
L
—
..
.
A
N
T
E
N
N
A
S PEAKE
‘
Connect left and right main speakers to the A
terminals. (The left speaker is on your left as you
face the speakers.) To hook up additional
speakers to the B terminals, please refer to page
i
.
We recommend the use of 18-gauge standard
lamp cord for connecting speakers to the
receiver. Strip back the insulation about ½” from
the end of a speaker’s connecting cord, expos
ing the two wire leads. Twist the filaments of
each lead to avoid a short circuit in the con
nection, and wrap each lead securely around
the terminal shafts. Tighten the terminal nuts.