Download Rockwell RC336D Specifications

HE863 family AT commands reference guide
80377ST10083a Rev.4 – 2012-02-01
+CGCLASS - GPRS mobile station class
Set command sets the GPRS class according to <class> parameter.
AT+CGCLASS=
[<class>]
Parameter:
<class> - GPRS class
“A” - WCDMA
“B” - GSM/GPRS
“CG” - class C in GPRS only mode (GPRS only)
“CC” - class C in circuit switched only mode (GSM only)
Read command returns the current value of the GPRS class in the format:
AT+CGCLASS?
AT+CGCLASS=?
3.5.3.7.2.
+CGLASS: <class>
Test command reports the range for the parameter <class>
GPRS Attach Or Detach - +CGATT
+CGATT - GPRS Attach Or Detach
Execution command is used to attach the terminal to, or detach the terminal from,
AT+CGATT=[
the GPRS service depending on the parameter <state>.
<state>]
AT+CGATT?
AT+CGATT=?
Example
Parameter:
<state> - state of GPRS attachment
0 - detached
1 - attached
Read command returns the current GPRS service state.
Test command requests information on the supported GPRS service states.
AT+CGATT?
+CGATT: 0
OK
AT+CGATT=?
+CGATT: (0,1)
Reference
3.5.3.7.3.
OK
AT+CGATT=1
OK
3GPP TS 27.007
GPRS Event Reporting - +CGEREP
+CGEREP - GPRS Event Reporting
Set command enables or disables sending of unsolicited result codes
AT+CGEREP=
+CGEV: XXX (see below) from TA to TE in the case of certain events occurring
[<mode>[,<bfr>]]
in the Packet Domain.
Parameters:
<mode> - controls the processing of URCs specified with this command
0 - Buffer unsolicited result codes in the TA. If TA result code buffer is full,the
oldest one can be discarded. No codes are forwarded to the TE.
1 - Discard unsolicited result codes when TA-TE link is reserved (e.g. in on-line
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 89 of 228