Download Crafstman 139.18803 Specifications

Security+® Universal Remote Control Conversion Kits
Item Number 18796 Ideal for:
1. Owners of Craftsman® garage door openers
manufactured before 1990 who need additional
remote controls.
2. Owners of Craftsman® or any other brand garage
door opener who wish to add the advantage of
Security+® rolling code technology to their home.
All Craftsman® Remote Controls can operate up to
3 Garage Door Openers
DIP-SWITCH CODING (19,683 CODES)
FOR GARAGE DOOR OPENERS
Match/Change the Code in New and Existing
Remote Controls (Set Code Switches in All
Remote Controls to Matching Positions)
For remote controls used with an existing 3-Function
Standard Remote Control Model 139.18778 or
3-Function Mini Remote Control Model 139.18779
to operate the same receiver(s), proceed as follows:
Locate the code switches in the 3-Function Mini
Remote Control by removing the case screw. Be
careful not to move circuit board components.
On the 3-Function Standard Remote Control, slide
the battery compartment cover back. Place remote
controls side by side as shown below.
With a pen or screwdriver, set code switches in your
new remote control to the same positions as in the
original remote control.
Model 139.18779
Model 139.18778
SET RECEIVER TO LEARN OR MATCH
REMOTE CONTROL(S) CODE
Garage Door Openers (with Receiver “SR” Button)
Make sure all remote controls are set to matching
code switch positions as described above.
1. Select a remote control push button to operate the
door opener. Press and HOLD the selected push
button.
2. Then press and release the red “SR” button on the
opener panel. The opener light will flash once.
Release the remote control push button.
The receiver has accepted the remote control code
and the opener will now operate the selected push
button. NOTE: If remote control push button is not
held down until the door moves, the receiver has not
accepted the code.
To use the Remote Control(s) with Other “SR” Button
Receivers: Select another remote control push button
to operate an additional garage door opener. Make
sure all remote controls used to operate receiver are
set to same code. Repeat Steps 1 and 2.
Garage Door Opener
(with “Smart” Button)
1
2
3
RED
WHT
BLK
Push Button Push Button Push Button
(+)
(0)
(-)
Model 139.18778
Model 139.18779
Match
Code
Switches
(2-9)
Code Switches (1-9)
42
SRT
Indicator
Code Button Light
Push Button
(-)
Push Button
(0)
Push Button
(+)
Select a remote control push
button to operate receiver
Code Switches (1-9)
REMOTE CONTROL PROGRAMMING
REMOTE CONTROL PROGRAMMING
43