Download ProForm 850 Elliptical User`s manual

ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver
wrench
, and rubber mallet
.
, adjustable
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 Hex Nylon
Locknut (77)–4
M6 x 14mm
Flat Head
Screw (55)–1
#8 x 1/2"
Screw (79)–6
M10 x 22mm x
1.5mm Washer
(63)–2
M6 x 18mm Patch
Screw (57)–6
M4 x 16mm
Screw (80)–4
M8 x 19mm Patch
Screw (65)–4
#8 x 2"
Screw (68)–4
M10 x 15mm Patch
Screw (71)–2
Barrel Nut (56)–1
M8 x 55mm Patch
Bolt (61)–4
M10 x 120mm Patch Screw (58)–2
5
M10 x 27mm Patch
Screw (64)–4