Download ARK G965 Specifications
Transcript
Intel Desktop Board DG965OT Technical Product Specification Table 17. PCI Interrupt Routing Map ICH8DH PIRQ Signal Name PCI Interrupt Source PIRQA PIRQB PIRQC PIRQD PIRQE PIRQF PIRQG PIRQH ICH8 LAN INTA PCI bus connector 1 INTD INTA INTB INTC PCI bus connector 2 INTC INTB INTA INTD IEEE-1394a controller INTA NOTE In PIC mode, the ICH8DH can connect each PIRQ line internally to one of the IRQ signals (3, 4, 5, 6, 7, 9, 10, 11, 12, 14, and 15). Typically, a device that does not share a PIRQ line will have a unique interrupt. However, in certain interruptconstrained situations, it is possible for two or more of the PIRQ lines to be connected to the same IRQ signal. Refer to Table 15 for the allocation of PIRQ lines to IRQ signals in APIC mode. PCI interrupt assignments to USB ports and Serial ATA ports are dynamic. 2.8 Connectors and Headers CAUTION Only the following connectors have overcurrent protection: Back panel and front panel USB, PS/2, and VGA. The other internal connectors/headers are not overcurrent protected and should connect only to devices inside the computer’s chassis, such as fans and internal peripherals. Do not use these connectors/headers to power devices external to the computer’s chassis. A fault in the load presented by the external devices could cause damage to the computer, the power cable, and the external devices themselves. This section describes the board’s connectors and headers. The connectors and headers can be divided into these groups: • • 50 Back panel I/O connectors (see page 51) Component-side connectors and headers (see page 52)