Download Pride Mobility Quantum Vibe Owner`s manual

V III.
OP E RAT ION
Speed Settings (Mode Key)
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is
5. The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are pre-set at the factory. If your Quantum Rehab Specialist changes the order of
these settings, please make note of these changes. Contact your Quantum Rehab Specialist for more information.
To select a speed setting:
1. Press the on/off key to power on the controller.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed
setting in the speed setting indicator.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting
in the speed setting indicator.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the
forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these accessories.
Off-board Charger/Programming Socket
You charge the power chair batteries through the 3-pin socket located on the front of the controller. Off-board charger
current should not exceed 12 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the charger socket.
See your Quantum Rehab Specialist for more information.
NOTE: The socket may also be used for reprogramming the controller. Contact your Quantum Rehab Specialist for more information.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module.
Power Module (Not shown)
Typically, the power module is mounted to the power base. The power module provides a power interface for the joystick
module. It routes the battery power to the motors and other powered accessories such as lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and power
interface between the power module, the lights, and/or the power seat actuator.
Vibe
www.quantumrehab.com
39