Download Simplicity 7800070 Specifications
Transcript
Operatm Chipping & Shredding Operation Type of Waste Permitted Size Limitations Notes Shredding Dry or moist organic material including leaves, 31ants,flowers, fruits, or vegetables. Branches and twigs up to 1/2" diameter and 18" long. Alternately chip or shred moist green waste with dry waste to avoid plugging of the discharge chute. Long, thicker tree limbs or small bunches of smaller sticks grouped together for ease of handling. Tree limbs and branches, or bundles of small sticks grouped for easier handling. Maximum diameter of approximately 3" (7,6 cm). Chipping Recommendations Process at a feeding rate that allows the rotor to keep up and maintain a high rate of speed. Bulky tree limbs should be pruned close to the main stem. Always use a shorter piece of wood to push end pieces into the chipper cone. Never place hands in the chipper cone. Never chip very hard or dry materials such as kiln dried dimensional lumber (2x4's etc.) or other building materials. Never use the chipper to process pressure-treated wood products. Vacuum Attachment Light, loose, dry waste such Small materials that will not obstruct the vacuum hose. as leaves, grass clippings, or sawdust. Storage Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps: Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed structure - see warning). Before starting the unit after it has been stored: Check all fluid levels. Check all maintenance items. Perform all recommended checks and procedures found in the engine owner's manual. Allow the engine to warm up for several minutes before use. 12 The vacuum is engineered for small, loose waste and for cleaning around decorative landscaping and flower beds. Twigs, wet leaves, and other bulky materials will clog the hose or obstruct the shredding chamber.