Download Muratec MFX-1200 Specifications

Attribute 1 - Individual Autodialer Setting (Equivalent to Memory Switch B:0)
7
Initial
Setting
1
6
0
5
0
4
0
3
0
2
1
1
0
0
1
Switch
Adjust
Usage/Comments
Busy tone detection
Sets this switch to “0” if the ring tone of remote unit
0: No
is mistaken for a busy signal.
1: Yes
Fallback pattern (bps)
2400
4800
7200
9600 14400
Set at 0: 2 times 2 times 2 times 2 times 2 times
Set at 1: 4 times 1 times 1 times 1 times 1 times
Overseas mode
Re-enables echo suppression that is disabled by
0: No
the CED signal (2100 Hz). Also ignores the first DIS
signal and transmits the DCS signal in response to
1: Yes
the second DIS signal.
V.29 Echo Protect tone
International telephone lines equipped with echo
0: No
suppression will cut the beginning portion of the
1: Yes
transmitted information which may cause the
receiver not to receive the training and data. To
protect the received image from degrading, a 0.5
second Echo Protect tone is placed prior to the
training using G3 high speed modem training (V.29).
Maximum transmit speed (kbps)
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
0 0 0 0 0 0
0
0
1
1 1
1
1
1
0 0 0 0 1 1
1
1
0
0 0
0
1
1
0 0 1 1 0 0
1
1
0
0 1
1
0
0
0 1 0 1 0 1
0
1
0
1 0
1
0
1
Note: The maximum speed for MFX-1200 is 14.4 kbps.
Attribute 2 - Individual Autodialer Setting (Equivalent to Memory Switch B:1)
Switch
7
Initial
Setting
0
Adjust
Usage/Comments
The time between reception of CFR and transmission of data
When CFR and data overlap due to line echo, increase the interval between CFR
and data transmission using this switch.
6
5
1
0
250 ms 500 ms 750 ms 1000 ms
Switch 7 0
0
1
1
Switch 6 0
1
0
1
Interval between DCS and TCF
When FTT is received after DCS and TCF signals due to line echo, increase the
interval between DCS and TCF signals using this switch.
4
0
Switch 5
Switch 4
3
2
1
0
0
1
1
1
75 ms 300 ms 450 ms 600 ms
0
0
1
1
0
1
0
1
Output attenuation
See table on next page.
3-38