1
Download Miele ESW 760-25 Technical information
Transcript
Technical Information Plumbing Information Water Inlet (Intake) Connection Type Hose Information Cold Water Supply Blue Lined Hose Hot Water Supply Red Lined Hose Table W-1: Plumbing information Connection Type 3/4in. pipe thread 3/4in. pipe thread Each water intake hose is equipped with screen filters - do not remove the filters. Water pressure should be 15-145 psi. (1-10 bar). Note Should the water supply pressure exceeds 145 psi. (10 bar), a pressure reducer must be installed on the supply. Should the water supply pressure be less than 15 psi (1 bar), insufficient water may be available for a complete fill. Single Cold Water Supply Connection If desired the washer can be connected to a single (cold) water supply by connecting both the hot and cold intake hoses to the supply valve using a “Y” adapter. Drain Connection The appliance is equipped with a 5 ft. (1.5 m) drain hose with a maximum delivery height of 4ft. (1.2 m) for connection to a drain as follows: Directly into a sink: hook the hose over the edge of the sink and secure it firmly (i.e. by tying the hose to the water faucet etc...). To a stand pipe: place the drain hose into a 1 1/2in. (38 mm) stand pipe and secure in place. To a floor drain: The machine is equipped with an airgap/antisiphoning system so that no minimum drain height is required. Extending / Increasing the Length of the Drain Line Maximum drain height can be increased by the installation of a booster pump installation kit; and an additional booster drain pump. Maximum drain height with this kit and pump installed is 8 feet and a maximum drain length of 15 feet. Contact the Miele Technical Support Center for further information 104
