Download Woods TSR60 Operator`s manual

DRIVELINE ATTACHMENT
Attach the rotary tiller to the tractor 3-point hitch (or
quick hitch if available). Do not attach driveline. Raise
and lower the tiller to determine maximum and minimum distance between the tractor PTO shaft and the
gearbox input shaft. If the distance is too large, the
driveline will be too short for proper engagement. If the
distance is too small, the driveline may bottom out in
operation and damage the tiller or tractor.
A
1-1/4"
If the driveline is too short, please call your Woods
dealer for a longer driveline.
If the driveline is too long, please follow the instructions
for shortening the driveline.
SHORTENING DRIVELINE
1. Move the tiller up and down to get the shortest possible distance between tractor PTO shaft and gearbox input shaft. Leave the tiller in the minimum
distance position. Install jack stands under the
tiller for support.
Figure 2. Determine Shield Length
5. Cut the upper shield to this overall dimension
2. Separate the driveline into two halves and connect
them to the tractor and the gearbox.
3. Place driveline halves parallel to one another to
determine how much to shorten the driveline.
Figure 3. Cut Shield
6. Place the cut portion of the shield against the end
of the shaft and use as a guide. Mark and cut the
shaft.
Figure 1. Drive Halves Placed Parallel
4. Measure from end of the upper shield to the base
of the bell on the lower shield (A). Add 1-1/4" to
dimension (A).
Figure 4. Cut Shaft to Length
7. Repeat step 6 for the other half of the drive.
MAN0814 (3/11/2010)
Operation 11