Download Miele DA 449-4 Technical data

Cleaning and care
^ After cleaning, leave the filters to dry
for a while on an absorbent surface
before putting them back in place.
To replace the stainless steel outer
filter
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
^ After cleaning the filters, press the
grease filter control for approx.
3 seconds to reset the operating
hours counter.
The indicator lamp will go out.
If the stainless steel outer filter and the
grease filter are cleaned before the
operating hours counter has reached
its maximum, the grease filter control
should be pressed for approx. 6
seconds to reset the counter to zero.
^ Fit the outer filter into the appliance
so that it hooks into the retainers at
the back, then push it upwards at the
front and make sure it engages in the
quick-release mechanism.
To replace the grease filter
^ Holding the grease filter at an angle,
fit it into the front of the chimney and
then push it into position along the
front edge.
^ Then push it up into position at the
back, making sure it clicks into
position on both sides.
21