Download Yamaha 5C Owner`s manual

U6E028E0.book Page 52 Tuesday, February 10, 2009 3:19 PM
Maintenance
Tightening torque:
9.0 Nm (0.92 kgf-m, 6.6 ft-lb)
7.
Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
Tightening torque:
9.0 Nm (0.92 kgf-m, 6.6 ft-lb)
EMU29302
Cleaning fuel tank
EWM00920
WARNING
Gasoline is highly flammable, and its vapors are flammable and explosive.
● If you have any question about properly
doing this procedure, consult your
Yamaha dealer.
● Keep away from sparks, cigarettes,
flames, or other sources of ignition
when cleaning the fuel tank.
● Remove the fuel tank from the boat before cleaning it. Work only outdoors in
an area with good ventilation.
● Wipe up any spilled fuel immediately.
● Reassemble the fuel tank carefully. Improper assembly can result in a fuel
leak, which could result in a fire or explosion hazard.
● Dispose of old gasoline according to local regulations.
1.
2.
Empty the fuel tank into an approved container.
Pour a small amount of suitable solvent
into the tank. Install the cap and shake
the tank. Drain the solvent completely.
ZMU03231
3.
Remove the screws holding the fuel joint
assembly. Pull the assembly out of the
tank.
4.
Clean the filter (located on the end of the
suction pipe) in a suitable cleaning solvent. Allow the filter to dry.
Replace the gasket with a new one. Reinstall the fuel joint assembly and tighten
the screws firmly.
5.
52