Download Westerbeke 46 Operator`s manual

I.
Check condition of zinc anode in heat exchanger.
Should material be flaking off the zinc, it should be scraped
clean, or be replaced by a good solid zinc pencil.
If it appears that a lot of material has been flaking off the
zinc, then it is advised that the end cap of the exchanger be
removed, and the flaked material be cleaned from that area of
the exchanger. A new end cap gasket should be on hand in case
it is needed when replacing the end cap.
ZINC #11885
*J.
3.
4.
5.
REPLACE
CLEAN/REPLACE
Check for proper movement and security of throttle and shift
linkage.
Servicing at every 100 hours of operation.
A.
Renewal of engine oil.
B.
Replacement of oil filter.
Servicing at every 200 hours of operation.
A.
Replacement of engine mounted fuel filter elements.
B.
Relacement of fuel filter
(cartridge type).
Servicing at every 500 hours of operation.
A.
Adjustment of engine idle, if necessary.
*B.
Tightening of bolts and nuts.
*C.
Adjustment of valve clearance.
26