Download BENDIX A-18 TRAILER ABS Specifications
Transcript
CONFIDENTIAL Bendix Commercial Vehicle Systems LLC Elyria, OH 44036 PRODUCT SPECIFICATION - BW-283-PR 6.5.4 Connectors All connectors must be securely connected to prevent environmental contamination or damage. All ABS electrical connectors should be greased for added protection against corrosion. If a connector is not joined to its mate or otherwise left exposed during the painting of the trailer, damage could be done to the connector. Tape, or other means of protection, must be used to assure the connector does not become contaminated. Refer to Section 3.2 for the standard connectors that are used with the TABS6 Trailer ABS system. 6.5.5 Routing and Securing of Wires Once assembled, all wheel speed sensor cables, power, ground and warning light connections must be properly restrained to prevent wire and connector damage. Fastening the pigtail harness leads to the control line, less than 12 inches from the TABS6 connector provides strain relief. In addition to these tie-wraps, it is necessary that any additional wiring be secured at approximate 18 inch intervals throughout their length. Speed sensor wiring coming out of the wheel ends should be routed away from moving brake components and secured to the axle to prevent excess cable length and wiring damage. The sensor wires should be secured along the service brake hoses leading to the TABS6 ECU pigtail. The stress loop allows the sensor to properly adjust but not to be pulled out of adjustment. Bendix does not recommend using standard tie-wraps to secure wiring harnesses directly to rubber airlines. This can cause premature wiring failure from excessive expansion when air pressure is applied. Non-metallic hose clamps or bow tie tie-wraps are preferred. TABS6 Trailer ABS Module Standard Tie-Wraps can be used for Synflex Tubing Tie-Wrap Provision @ TABS6 Housing (Optional) Non-Metallic Hose Clamps or Bow Tie Tie-Wraps should be used for Rubber Airlines Figure 29: Trailer ABS Routing & Securing of Wire Harnesses SPEC. BW-283-PR 73 SHEETS SHEET NO. 62 DOCUMENTO CONTROLADO DE FORMATO ELECTRÓNICO: Antes de utilizarlo se requiere verificar el nivel de revision o la suficiencia. CONTROLLED ELECTRONIC MEDIA DOCUMENT: Verification of revision level or adequacy is required prior to use.