Download ADS 250MX Operating instructions

Section 12 - Flame Adjustment
!
NOTE: ALWAYS WEAR EYE, FACE AND BREATHING PROTECTION AND
PROTECTIVE CLOTHING WHEN INSPECTING OR ADJUSTING FLAME.
Lift the inspection port cover on the front of the combustion chamber to observe the flame.
The flame tips should extend 3/4 of the way into the combustion chamber. When the unit is
adjusted properly the ash inside the chamber will be white to off white.
Flame tips touching the target brick (end of the chamber) will cause combustion chamber
damage. This condition may be caused by a worn nozzle, or excess burner fuel pressure.
When this condition exists, the ash in the chamber will
be brown to black.
Flame Adjustment - Visual
Flame is over-fired (Fig. 11).
t%BSLZFMMPXUPPSBOHFJODPMPS
t5IFøBNFJTIJUUJOHUIFXBMMTöMMJOHUIFDIBNCFS
XJUIBTNPLFZøBNF$PSSFDUJNNFEJBUFMZPSDIBNCFS
NBZCFEBNBHFE
t%FDSFBTFGVFMQSFTTVSFXIFOVTJOHBCZQBTT
SFHVMBUPSBOEBEKVTUDPNCVTUJPOBJS0QFOUIF
DPNCVTUJPOBJSCBõFPOUIFTJEFPGUIFCVSOFS"JS
QSFTTVSFNBZBMTPOFFEUPCFBEKVTUFE
Figure 11
BAD FLAME
The flame is too big, creating an overfire condition
Problem:5PPMBSHFPGBøBNFEBSLZFMMPXJODPMPS
1. 5PPNVDIGVFMQSFTTVSFPOMZXIFOVTJOHBCZQBTT
SFHVMBUPS
2. /PUFOPVHIDPNCVTUJPOBJS
3. /PUFOPVHIBUPNJ[JOHBJSQSFTTVSF
4. 0QFODPNCVTUJPOBJSCBõFPOUIFTJEFPGUIF
CVSOFS
5. "TIJOTJEFUIFDIBNCFSJTEBSLCSPXOUPTPPUZ
CMBDLJODPMPS
Flame is under-fired (Fig. 12)
t5IFøBNFJTMJLFBCMPXUPSDI
t-JHIUZFMMPXUPXIJUFJODPMPS
t$IFDLUPTFFJGQSFIFBUFSCMPDLJTIPU
t$IFDLBJS14*JUNBZCFUPPIJHI"EKVTUJO-#
JODSFNFOUT
t0JMQSFTTVSFPOMZXIFOVTJOHBCZQBTTSFHVMBUPS
5IFDPNCVTUJPOBJSCBõFNBZOFFEBEKVTUNFOU
Figure 12
BAD FLAME
The flame is too short
Figure 13
GOOD FLAME
The flame length is approximately 3/4
of the chamber
QUESTIONS?... Contact Customer Service at 1-888-370-6531 M-F 8:00 am- 4:15 pm CST
30