Download Sears 417 Use & care guide

Solutions to Common Problems
Common Washing Problems, continued
PROBLEM
Yellow buildup
of body soil on
synthetic fabrics
Yellow or brown
rust stains
Residue stains /
buildup, mold or
mildew stains in
gasket
POSSIBLE CAUSES
• Agitation time too short.
• Wash water temperature
too low.
• Not enough detergent.
SOLUTIONS
• Soak in detergent booster or product
containing enzymes.
• Wash in hottest water safe for fabric
using casual cycle.
• Increase detergent.
• Add bleach safe for fabric or treat
with color remover.
• Iron or manganese in water • To restore discolored load of whites,
supply, water pipes, or water
use rust remover safe for fabric.
heater.
• Do not use chlorine bleach to remove
rust stains. It may intensify discoloration.
•
•
•
•
•
•
Residue stains / •
buildup, mold or •
mildew stains in •
dispenser drawer
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Overloading wash drum.
Leaving a wet load set in
washer.
Cold water washes which
may not completely dissolve
and remove detergents.
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Water in fold of
flexible gasket
• Result of washing and part
of normal operation.
Odor
•
•
•
•
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Leaving a wet load remain
in washer.
• Cold water washes which
may not completely dissolve
and remove detergents.
•
•
•
•
PREVENTIVE MEASURES
• Select correct wash cycle.
• Use correct amount of detergent.
• Wash synthetics frequently using
hot or warm water.
• Use nonprecipitating water softener.
• Before washing, run hot water for
a few minutes to clear lines.
• Drain water heater occasionally.
• For an ongoing problem, install
an iron filter in your water supply
system.
Perform Clean Washer cycle
• Run dehumidifier in laundry room.
Scrub gasket with Comet™ Spray Gel • Avoid overfilling detergent and
Mildew Stain Remover using brush to
fabric softener compartments of
remove stains.
dispenser.
Use only HE (high efficiency detergent) • Dry the inside of washer and gasalong with recommended dosage.
ket after every run.
Remove wash load immediately upon
cycle completion.
• Avoid overfilling detergent and
• Remove dispenser drawer and wipe
fabric softener compartments of
dispenser and inserts with combination
dispenser.
of ¾ cup liquid chlorine bleach and
one gallon hot water. Rinse well, and
repeat if necessary. Return drawer to
location. NOTE: Wear rubber of latex
gloves. Protect floor and clothing from
bleach damage.
• Use only HE (high efficiency detergent)
along with recommended dosage.
• At the end of each wash, dry inside
of gasket fold with clean dry towel all
around gasket.
• Leave door and dispenser drawer
• Perform Clean Washer cycle.
open for a few hours after use or
• At the end of each wash, dry inside of
whenever washer is not in use.
gasket fold with clean, dry towel all
around gasket.
• Use only HE (high efficiency detergent)
along with recommended dosage.
• Remove wash load immediately upon
cycle completion.
• Pour one cup liquid chlorine bleach in
standpipe; let remain a day and flush
with water.
24