Download Allied Vision Technologies AVT GigEGoldeye Technical information

GigE IR & scientific camera and driver features
SensorTemperatureSetpointValue [Float] R/W
The setpoint temperature, in °C, corresponding to the setpoint selected in
SensorTemperatureSetpointSelector.
TimestampLatch [Command]
Captures timestamp and stores in TimestampLatchValue.
TimestampLatchValue [Integer] R
Unit: Camera clock ticks
Value of timestamp, when latched by TimestampLatch.
TimestampReset [Command]
Resets the camera’s timestamp to 0.
DigitalIOControl
LineIn
Signal source of the strobe timing unit. See LineOutSource for descriptions.
LineInGlitchFilter [Integer] R/W
Range: [0–50000]
Default: 0
Unit: ns
Ignores glitches on the LineIn input line with pulse duration less than set
value.
Note

Setting LineInGlitchFilter value increases
latency of FrameTrigger by same amount.
LineInLevels [Integer] R
A 4-bit register where each bit corresponds to a specific LineIn input. For example, when this value returns 2 (0010), LineIn2 is high and all other Line input
signals are low.
LineInSelector [Enum] R/W
Possible values: LineIn1, LineIn2
Default: LineIn1
Select the LineIn to control with LineInGlitchFilter.
LineOut
Used for synchronization with other cameras/devices or general purpose outputs.
LineOutLevels [Integer] R/W
Output levels of hardware line outputs, for output(s) in GPO mode.
GigE Camera and Drivers Features V3.0.0
This document is a master document for all Allied Vision GigE camera models and is NOT camera specific
68