Download Multitech MTPSR3-200 User guide
Transcript
ProxyServer User Guide Command: +ES=6 Enable Synchronous Buffered Mode Values: n/a Description: Allows an H.324 video application direct access to the synchronous data channel. On underflow, the modem sends HDLC flag idle (0x7E) to the remote modem. This special error correction mode is overridden by any of the following commands: &F, &M, &Q, and \N. +ES = ? shows the only allowed value. Command: &&S Values: Description: Speaker Codec Loopback n/a Provides a loopback from the microphone to the speaker. For testing and debugging only. Command: %T94 Values: Description: Testing External RAM n/a This command is used for testing the external RAM. Enter AT%T94<cr> to determine the status of external RAM. The response you should receive will be either "FAIL" or "PASS" Command: %T125 Testing DSP 56K Code Version/Checksum Values: n/a Description: Entering AT%T125<cr> tests the DSP56K code version and checksum running in external RAM. Upon issuing this command the user may then issue ATI4<cr> to get DSP version or ATI1<cr> to get DSP checksum in RAM. Entering AT%T124<cr> tests the DSP56K code version and checksum running in internal ROM. Upon issuing this command the user may then issue ATI4<cr> to get DSP version or ATI1<cr> to get DSP checksum in ROM. 108 MTPSR3-200