Download RedMax EB7001RH Specifications

4. Service Guide
4-7 Crankcase Assembling
Bearings, snap ring, oil seal configuration and installation position differ depending on type.
Properly install each part and reassemble the crankcase referring to the corresponding type’s drawing.
For bearing and oil seal installation, refer to the explanation on page 23.
HB23 Series, HBZ26 Series
Construction
Snap Ring
Bearing
Push the bearings until they
contact the crankcase.
【Starter Side】
】
Oil Seal
【Fan Side】
】
Oil Seal
Align the oil seal surface with
the crankcase surface.
Bearing
Push the bearings until they
contact the snap ring.
Crank Case
Push the oil seal within 0 to
0.5 mm (0.02 in.) from the
crankcase surface.
EBZ30 Series
Construction
Lubrication Hole
Lubrication Hole
Bearing
Push the bearings until they
contact the crankcase.
Snap Ring
Do not cover the lubrication
hole with the snap ring.
【Fan Side】
】
Oil Seal
【Starter Side】
】
Oil Seal
Snap Ring
Push the oil seal within 3.3
to 3.8 mm (0.13 to 0.15 in.)
from the crankcase surface.
Bearing
Push the bearings until they
contact the snap ring.
Crank Case
Push the oil seal within 0 to
0.5 mm (0.02 in.) from the
crankcase surface.
EB4300
Construction
Snap Ring
Bearing
Push the bearings until they
contact the crankcase.
【Fan Side】
】
【Starter Side】
】
Oil Seal
Push the oil seal until
its surface comes trim
with the crankcase
edge surface.
21
Oil Seal
Bearing
Push the bearings until they
contact the snap ring.
Crank Case
Push the oil seal
until its surface
comes trim with
the crankcase
edge surface.