Download M10 Reference Manual

Parameter
Speed
Description
Select the data transfer speed supported by your modem.
Flow−control
off Flow control is deactivated.
When you are not sure which type of flow
control your modem supports, do not
change this setting. The factory default
setting is Off.
crtscts Hardware flow control
Note:
Modem Type
Xon/Xoff are currently not supported.
Analog Analog telephone modem
GSM GSM model (mobile phone with data transfer,
e.g. Siemens MC35, Nokia 30)
Null Null modem
A null modem is a special RS232 cable that has
certain pins connected in a manner that a
modem connection is simulated. In this cable,
certain (at least the send and receive pins) or
all pins are cross−connected.
Modem Mode
In You can dial into the camera using the modem.
Out The camera can dial out, e.g. for transferring
images to the Internet.
In/Out You can dial into the camera or the camera can
dial out.
Note: Only one channel is available so that dialing in
and out does not work simultaneously.
Termination Reboot
When you set this parameter to On, the camera will reboot every
time after it has dialed out. This means that the internal image
storage is deleted and local network connections are
interrupted.
Note: It is recommended to use this setting only when
the camera does not send images frequently.
Dial Timeout
The maximum time the camera should wait for a connection to
be established.
Modem Init out
Enter the AT commands that your modem needs for initializing
an outgoing call. Precede each quote character by a backslash
(\").
Modem Init in
Enter the AT commands that your modem needs for initializing
an incoming call. Precede each quote character by a backslash
(\").
Modem disconnect
Enter the AT commands that your modem needs for terminating
a call. Precede each quote character by a backslash (\").
Phone Number
Enter the telephone number that you want the modem to use for
dialing out.
26 The Serial Interface
60