Download Security Link SL150 Troubleshooting guide
Transcript
Section 2 - Installing the Control Wiring the AC Transformer 1321 Transformer Wire the 1321 Transformer to terminals 1 and 2 on the control board. See wiring table below to determine wire gauge. Use caution when wiring the transformer to the control panel to guard against blowing the fuse inside the transformer (the fuse is nonreplaceable). 4300 Transformer If you are going to use a 4300 Transformer Interface (required if Powerline Carrier devices will be used), connect the 4300 Transformer’s terminals as follows: 1. Connect terminals 1, 3 (AC), and 2 (Ground) to control board terminals 1, 2, and 25, respectively (see Figure 5). See table below to determine wire gauge to use. WIRING TABLE Distance of Transformer From the Control Panel Up to 50 feet 50-100 feet 100-250 feet Wire Gauge to Use # 20 # 18 # 16 Wiring to the AC transformer must not exceed 250 feet using 16-gauge wire. The voltage reading between terminals 1 and 2 of the control must not fall below 16.5VAC, or an AC LOSS message will be displayed. Do not plug the transformer into the AC outlet until you are instructed to do so later in the manual. 2. Wire the other three terminals (Sync, Data, Com) on the 4300 Transformer. Wires from these terminals must be connected to a 9-pin connector on the control board (using a 4142TR Cable supplied with the 4300 Transformer), as shown in Figure 5. These particular wires can be 24-gauge or larger, and can be run along with the AC and ground wires to the control panel. 4300 TRANSFORMER/INTERFACE 1 2 25 3 2 Sync Data Com 4 5 6 GRAY 1 9-PIN CONNECTOR ON CONTROL BOARD YELLOW WHITE RED GREEN BROWN BLUE BLACK Earth AC Ground AC VIOLET 1 2 3 4 5 6 7 8 9 4142TR CABLE THESE WIRES (7, 8, 9) NOT USED TERMINALS ON CONTROL BOARD Figure 5. Connections of 4300 Transformer to the Control Board 2–5