Download Dynex DX-24E310NA15 System information

Dynex 24" LED TV
DX-24E310NA15
15
Coaxial (good)
On your TV
Coaxial cable
Coaxial cable
connector
Cable or
satellite box
Side of TV
ANT/CABLE IN
jack
1 Make sure that your TV’s power adapter is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or cable TV
wall jack.
4 Plug your TV’s power adapter into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press or to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 49.
Notes
• Use a coaxial cable to eliminate interference and noise from
radio waves.
• Do not bundle the coaxial cable with the power adapter or
other cables.
www.dynexproducts.com