Download Dimplex DAC 12001 Specifications
Transcript
Dehumidification. NOTE! The machine operates in the cooling mode but it does not lower the room temperature. It absorbs the excessive humidity present in the air. 1. Plug the unit into a proper electrical outlet. 2. Position the exhaust tube as shown or remove from the air-conditioner. 3.Turn the TIMER to position ON or 1 to 8 hours automatic timer setting. 4. Set the FAN SPEED control to the desired output of airflow, high or low. 5. Set the THERMOSTAT to the maximum cooling position. 6.When the water tank is full, the light above 'Power' switch will light and the compressor will shut off automatically, the fan will stay on circulating the air. At this time, you must empty the water tank as described "Draining the Condensed Water". Continuous Drainage. In very humid conditions to avoid the unit from continually shutting down when the water tank is full the unit can also be continuously drained if a convenient drainage position is available. Important! The water is only gravity drained therefore the tube must lay lower and drain at a lower level than the outlet tube at the rear of the air conditioner. • Before operating the air conditioner, remove the water stopper, take out the rubber plug and connect a PVC tube 12mm diameter. 10