Download DEI 600HF Installation guide

2-pin
micro
LED
plug
475T
remote
transmitters
2-pin
mini
red
VRS®
plug
504D Plug-in
Stinger® shock
sensor
2-pin
mini
blue
Valet®/
Program
plug
Primary
harness
H1
Relay
harness H2
514T
soft-chirp
siren
Plug-in
Status LED
Plug-in
Valet®/Program
switch
Plug-in
V.R.S.
Switch
Pre-Wired
8618 Starter
Kill Relay
INSTALLATION POINTS TO REMEMBER
Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an airbag, avoid
disconnecting the battery if possible.
IMPORTANT! Many airbag systems will display a diagnostic code through their warning light after
they lose power. Disconnecting the battery requires this code to be erased, a procedure that can
require a trip to the dealer.
Before beginning the installation:
• Check with the customer on Status LED location.
• Remove the domelight fuse. This prevents accidentally draining the battery.
• Roll down a window to avoid being locked out of the car.
After the install:
• Test all functions. The "Using Your System" section of the Owner's Guide is very helpful when testing.
• When testing, don’t forget that this system is equipped with Nuisance Prevention CircuitryTM.
NPC™ can bypass trigger zones, making them appear to stop working. See Final Testing, page 24.
© 1999 Directed Electronics, Inc. Vista, CA
2
N448 3/99