Download Memorex MPH-1089 Service manual

Body and Accessories
Body Rear End 8-11
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: Do not use the jacknuts supplied in the kit. Use
rivnuts (TX016183) instead.
3. Install the side rail over the adapter plates, with the 2
outer bolts and the 2 upper facing bracket bolts and nuts.
Tighten
•
Tighten the 2 outer bolts to 26 N•m (19 lb ft).
•
Tighten the 2 upper facing bolts to 8 N•m (70 lb in).
4. Install side rail adapter plates, front and rear, by aligning
the bolt holes to the holes in the box.
5. Install the troop seats (1). Refer to Seat Replacement –
Troop in Seats.
6. Install the side struts, top bows (2) and cargo cover.
Refer to Cargo Cover Top Bows Replacement and Cargo
Cover Strut Replacement.
Cargo Cover Front End Rail Replacement
Removal Procedure
1. Remove the cargo cover from the front of the cargo cover
assembly. Refer to Cargo Cover Replacement.
2. Remove the 4 bolts from the front end rails as needed.
3. Remove the 4 rivnuts by drilling out (if damaged).
2006 LSSV Service Manual Supplement