Download Envoy NT9010A Installation guide

Chapter 1: Quick Set Up
You can use the Forward (Playback) button to advance to the next section in
Flash Programming, and the Backward (Record) button to return to the previous
section.
5. Be sure to record all the zone serial numbers and your programming choices in
the NT9010 Programming Worksheets.
Here are some notes about system programming done through Flash Programming.
Zone Definitions
When you enter a serial number for a device into the NT9010 Flash Programming,
the unit will analyze the number to determine what kind of device you are enrolling. Based on the type of device, the system will make the following programming
choices:
Device Type
Zone Definition
Other Programming
Door/window contact
Delay 1 (Type [01])
(2XXXXX, including hardwired contacts entered as
200001 and 200002)
For hardwired zones (serial
numbers 200001 and
200002), Zone Supervision
disabled (section [804])
Motion or glassbreak
detector (3XXXXX)
Interior Stay/Away
(Type [05])
None
Smoke detector
(4XXXXX)
Delayed 24 Hour Fire None
(Type [87])
Wireless key (6XXXXX)
None
None
NOTE: To ensure that the NT9010 works properly, you should enroll all
entry/exit point zones first.
NOTE: PIR’s covering entry points should be zone type [06] Delay Stay/Away
[01] Delay 1 Zone: If this zone is violated when the system is armed (e.g.
door or window is opened), the entry delay will begin. The buzzer
will sound to warn the user that the system must be disarmed. If the
system is not disarmed before the entry delay expires, an alarm will
be generated.
[05] Interior Stay/Away Zone: If this type of zone is violated when the
system is armed (e.g. the motion detector senses motion), an instant
alarm will be generated unless a Delay Zone is violated first. If a Delay
Zone is violated first, this zone will also follow the entry delay.
The zone will be automatically bypassed under the following conditions:
■
■
■
the NT9010 is armed in the Stay Mode
the NT9010 is armed without entry delay ([✱][9] arming)
the NT9010 is armed with an access code and during the exit delay a
Delay zone is NOT violated (user does not go through the entry/exit
door).
If zones are automatically bypassed, the user can reactivate the zones
by entering [✱][1].
10