Download Directed Electronics 554R Installation guide

using your system
➜ active arming
Press
for one second to arm the system. The vehicle’s lights
will flash once, the doors will lock, the siren will chirp once, and
while the system is armed, the status LED will blink approximately once per second to indicate the system is actively
protecting the vehicle.
The transceiver will beep once (or vibrate). The arm icon (29)
will appear and remain displayed on the LCD.
Bypass Notification
If the siren chirps again, the transceiver beeps again, and the status
LED blinks in a pattern, a protected entry or sensor input is active
and its icon will be displayed on the transceiver LCD. This is
called bypass notification. Refer to the Diagnostic section of this
manual for information about bypass notification.
➜ passive arming
The system can be programmed to arm automatically. This is
called passive arming. In passive arming mode the system will
arm itself 30 seconds after the user exits the vehicle and closes all
protected entry points.
Passive arming sequence
1. Turn the ignition off and exit the vehicle.
2. Close all protected entry points (doors, hood, trunk).
18
© 2003 directed electronics, inc.