Download Vetus M2.06 Technical data

Operating media
Coolant
Coolant fluid
Water quality for coolant preparation
The preparation and monitoring of coolant in inter-cooled engines
is especially important because corrosion, cavitation and freezing
can lead to engine damage. Use as coolant a mixture of a cooling system protective liquid (anti-freeze, ethylene glycol based)
and tap water.
Use preferably tap water.
In tropical climates, where anti-freeze availability may be limited,
use a corrosion inhibitor to protect the engine cooling system.
The concentration of the cooling system protective liquid in the
coolant should not fall below/exceed the following limits:
Cooling system protective
Water
Protection against
liquid (Anti-freeze) freezing to
max. 45 vol%
55%
-35°C (-31°F)
40 vol%
60%
-28°C (-18°F)
min. 35 vol%
65%
-22°C (-8°F)
The protective liquid concentration must be maintained under all
circumstances. Therefor if coolant must be added always use the
same mixture of anti-freeze and tap water.
If an other available fresh water is used; the values given below
must not be exceeded.
Water quality
min.
pH-value at 20°C (68°F)
6.5
max.
8.5
Chloride ion content [mg/dm3]
–
100
Sulfate ion content [mg/dm3]
–
100
Total hardness [degrees]
3
12
Never use sea-water or brackish water.
Cooling system protective liquids must be disposed of
in accordance with environmental regulations.
67