Download Crestron Lighting Design Installation guide

230 V Lighting Design Guide
230 V Lighting Control Modules
Air-gap relays are provided on every channel output allowing individual circuits to be serviced without disabling the
entire module. Terminal blocks are sold separately to enable termination of the wiring anytime prior to installing the
module.
Model
Load
Rating
CLXI-1DELV4
Four channels of dimming for
electronic low-voltage and
incandecent loads
Each channel is rated for
2300 watts with local
module rating of 2990 watts
CLXI-1DIM4
Four channels of dimming
Each channel is rated for
for incandecent, magnetic
2300 watts with a total
low-voltage, neon/cold
module rating of 2990 watts
cathode, and dimmable 2-wire
fluorescent loads
CLXI-2DIM2
Two independent channels
of dimming for incandescent
magnetic low-voltage, neon/
cold cathode, and dimmable
2-wire fluorescent loads
Each channel is rated for
2300 watts with local
module rating of 4600 watts
when fed from two separate
16 amp feeds
CLXI-2DIM8
Eight channels of dimming
for incandescent, magnetic
low-voltage, neon/cold
cathode, and dimmable 2-wire
fluorsecent loads, actually
composed of two independent
four-channel dimmers in a
single module
Four independent channels of
switching for high-inrush loads
such as motors, HID lighting
and fluorescent ballasts
as well as incandescent,
low-voltage and neon/cold
cathode lighting
Control of up to 4
bidirectional motors for
drapery, blinds, projection
screens, lifts, etc.
Each channel is rated for
2300 watts with local
module rating of 5980 watts
when fed from two separate
16 amp feeds
CLXI-4HSW4
CLXI-1MC4
20
Each channel is rated for 16
amps or 1 hp, with a total
module rating of 64 amps
when fed from four separate
16 amp feeds
Each channel is rated for 8
amps or 1 hp, with a total
rating of 13 amps
Doc. 4859C | crestron.com