Download Crate TX50DE Specifications

C R AT E
THE REAR PANEL:
DC CHARGER
PLUG
DC CIGARETTE
LIGHTER ADAPTOR
LIT WHEN
CHARGING
15V DC
12V DC
25
26
POSITIVE
NEGATIVE
26. DC CIGARETTE LIGHTER ADAPTER, 12
VDC: Plug the small round connector of the
optional 12-volt car adapter into this jack to
play the amplifier from a vehicle, instead of
the internal battery. NEVER connect the
supplied 15-volt charger to this jack! See
page 4 for additional information.
25. DC CHARGER PLUG, 15VDC: Plug the
small round connector of the supplied AC
wall adapter into this jack to charge the
internal battery. The LED next to the jack
glows red when the amp is charging. See
page 4 for additional information.
ABOUT THE INSERT JACK:
The Insert jack (#8) lets you patch external effects into the amplifier just prior to its power amp
stage, as shown below. Set the mix controls on the external effects units to “full effect” (100% wet).
Connecting to the effect’s
insert jack with a stereo cable:
TO
INSERT
JACK
TIP: LINE IN (RETURN)
RING: LINE OUT (SEND)
SLEEVE: GROUND
Connecting to the effect with a
stereo-to-mono Y-cable:
TO
INSERT
JACK
TIP: LINE IN (RETURN)
TO
INSERT
JACK
RING: LINE OUT (SEND)
SLEEVE: GROUND
RING: LINE OUT (SEND)
SLEEVE: GROUND
DUAL MONO 1/4" TO
STEREO 1/4" ADAPTER
RING
DUAL MONO 1/4" TO
STEREO 1/4" Y-CABLE
RING
TIP
(IF EFFECT IS INVERTING)
TIP: LINE IN (RETURN)
YPP117
STP201, 3'
STP202, 6'
STP203, 9'
T IP
(IF EFFECT IS NON-INVERTING)
STEREO 1/4" TO
STEREO 1/4" CABLE
Connecting to the effect with a
stereo-to-mono adapter and cables:
MONO 1/4" TO
MONO 1/4" CABLES
TO
STANDARD
INSERT
JACK OF
EFFECT
8
TO
INVERTED
INSERT
JACK OF
EFFECT
TO
MONO
OUTPUT
JACK OF
EFFECT
TO
MONO
INPUT
JACK OF
EFFECT
TO
MONO
OUTPUT
JACK OF
EFFECT
TO
MONO
INPUT
JACK OF
EFFECT