Download DCS RDT-366 Specifications

TROUBLESHOOTING
RANGES & COOKTOPS
PROBLEM
NON FUNCTIONAL
POSSIBLE CAUSE
NO ELECTRICITY OR
GAS SUPPLY
TURN ON GAS SUPPLY VALVE
TECHNICAL
CALL AUTHORIZED SERVICE
NO ELECTRICITY
CHECK CIRCUIT BREAKERS
NO GAS
CHECK GAS SUPPLY AT WALL
CHECK CIRCUIT BREAKERS
VERIFY GAS TYPE (SEE PAGE 30 FOR
LOCATION OF
LABEL
WRONG GAS
ONE OR MORE BURNERS
WILL NOT LIGHT
INCORRECT FLAME
SOOTY BURNER FLAME
SOLUTION
DIRTY BURNERS
CLEAN BURNERS
BURNERS MIS-ALIGNED
ALIGN & REASSEMBLE BURNERS
WATER IN BURNER(S)
DIS-ASSEMBLE & DRY BURNER(S)
DIRTY ELECTRODE
CLEAN BURNER ELECTRODE
TECHNICAL
CALL AUTHORIZED SERVICE
TOO LARGE OR SMALL
MIS-ALIGNED BURNER ASSY
VERIFY GAS TYPE (SEE LABEL ON BACK)
REALIGN AND RE-ASSEMBLE BURNER ASSY (PAGE 23)
RANGE OVENS
PROBLEM
POSSIBLE CAUSE
NO ELECTRICITY
NO OVEN LIGHT
SOLUTION
CHECK CIRCUIT BREAKERS
CHECK PLUG AT WALL (RDT,RGT & RGTC)
LOOSE BULB
BE SURE BULB IS SECURE IN SOCKET
BURNED OUT BULB
REPLACE BULB
NO GAS
CHECK FOR PROPER TOP BURNER OPERATION
NO ELECTRICITY (CHECK OVEN LIGHT)
NO OVEN HEAT (BAKE)
CHECK CIRCUIT BREAKERS
CHECK PLUG (RDT,RGT & RGTC)
IMPROPER SETTINGS
VERIFY PROPER SETTINGS ON KNOB & SELECTOR
BUTTONS (IF APPLICABLE)
TECHNICAL
CALL AUTHORIZED SERVICE
IMPROPER SETTINGS (SEE NO BAKE)
VERIFY PROPER SETTINGS
TECHNICAL
CALL AUTHORIZED SERVICE
INSUFFICIENT PRE-HEAT TIME
ALLOW OVEN TO PREHEAT BEFORE BAKING
IMPROPER SETTINGS
VERIFY PROPER SETTINGS ON KNOB & SELECTOR
BUTTONS (IF APPLICABLE)
IMPROPER UTENSILS/PLACEMENT
USE PROPER UTENSILS & PLACE THEM PROPERLY (SEE
USE & CARE)
TECHNICAL
CALL AUTHORIZED SERVICE
NO CONVECTION
NO CONVECTION PAN
CHECK FOR AIR MOVEMENT
CONVECTION NOISY
TECHNICAL
CALL AUTHORIZED SERVICE
NO OVEN BROIL
UNEVEN BAKING
RANGE GRIDDLE & GRILL
PROBLEM
POSSIBLE CAUSE
NO ELECTRICITY OR GAS SUPPLY
NON FUNCTIONAL
LOW HEAT
SOLUTION
TURN ON GAS SUPPLY VALVE
CHECK CIRCUIT BREAKERS
RADIANT TRAY IMPROPERLY INSTALLED
RE-INSTALL RADIANT TRAY CORRECTLY
TECHNICAL
CALL AUTHORIZED SERVICE
PLUGGED BURNER PORTS
SEE PAGE 23 FOR BURNER CLEANING PROCEDURE
29