Download Vanguard VYGF33NRA Installation manual

INSTALLATION
Optional Wireless Hand-Held Remote Control Accessories
17
17
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES (GHRCB and
GHRCTB)
Installing Remote Receiver Unit
1.
2.
3.
4.
5.
6.
Disconnect switch wires from the control valve.
Remove screws attaching switchplate.
Remove switch plate (see Figure 33). Discard after removing.
Install remote receiver unit onto gas log heater base using
mounting clips.
Push clips firmly into place (see Figure 34).
Connect wires as shown in Figure 35.
Remote
Switch
Bracket
Ignitor
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to operate this
heater with the wireless hand held remote control set. Install one
battery in the receiver and one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1.
2.
3.
4.
Locate back of receiver under front burner of heater.
Locate the battery clip mounted on the back of the receiver.
Slide a 9-volt battery through the clip.
Attach the terminal wires to the battery.
Remote
Receiver
Terminal
Wires
Screw
Battery Clip
9-Volt Battery
Switch Plate
Wires
Figure 33 - Switch Plate and Wiring Harness
Figure 36 - Installing Battery in Remote Receiver
Mounting
Clips
Installing 9-Volt Battery in Hand-Held Remote
Control Unit
1.
2.
3.
Remote Receiver
Figure 34 - Installing Remote Receiver
Remove battery cover on back of remote control unit.
Attach terminal wires to the battery. Place battery into the battery housing.
Replace battery cover onto remote control unit.
Model
Terminal GHRCB
Wires
Battery
Cover
Remote
Control Unit
Model
GHRCTB
White Wire
From
Receiver
Valve
Red Wire From
Receiver
Figure 35 - Connecting Wires
9-Volt
Battery
Battery
Housing
Figure 37 - Installing Battery in Hand-Held Remote Control Unit
For more information, visit www.desatech.com
105270-01H