Download Athena C.5 Installation manual

Table of Contents
5. Input Parameters – Required.................................................................. 5-1
5.1
Introduction ................................................................................................... 5-1
5.2
Calibration Must Be Appropriate for Input Type.............................................. 5-1
5.3
Input Jumper Settings Must Match Input Type ............................................... 5-2
5.4
Input Menu Parameter List............................................................................. 5-4
5.5
Specifying the Input Type .............................................................................. 5-6
5.5.1
Parameter Used ..................................................................................... 5-6
5.5.2
Procedure for Viewing the Currently Selected Input Type........................ 5-8
5.5.3
Procedure for Changing the Input Selection ............................................ 5-8
5.6
Configuring Input Parameters for RTD and Thermocouple Input Types .......... 5-9
5.6.1
Applying a Bias to the Temperature Input................................................ 5-9
5.6.2
Specifying the Setpoint Range When a Temperature Input is Used ....... 5-10
5.6.3
Applying an Input Filter When a Temperature Input is Used .................. 5-10
5.7
Configuring Input Parameters for Linear Inputs ............................................ 5-12
5.7.1
Applying a Bias to the Linear Input........................................................ 5-12
5.7.2
Scaling the Linear Input ........................................................................ 5-13
5.7.3
Specifying the Setpoint Range When a Linear Input Is Used ................. 5-14
5.7.4
Applying an Input Filter When a Linear Input is Used ............................ 5-14
6. Display Parameters – Required .............................................................. 6-1
6.1
Introduction ................................................................................................... 6-1
6.2
Configuring Display Parameters for RTD and Thermocouple Input Types ...... 6-3
6.2.1
Choosing the Decimal Position When a Temperature Input Is Used ........ 6-3
6.2.2
Specifying the Display Filter When a Temperature Input Is Used............. 6-3
6.2.3
Choosing the Unit of Measure When a Temperature Input Is Used.......... 6-4
6.2.4
Blanking the Display of the Setpoint When a Temperature
Input Is Used........................................................................................... 6-4
6.3
Configuring Display Parameters for Linear Input Types.................................. 6-5
6.3.1
Choosing the Decimal Position When a Linear Input Is Used................... 6-5
6.3.2
Specifying the Display Filter When a Linear Input Is Used ....................... 6-5
6.3.3
Blanking the Display of the Setpoint When a Linear Input Is Used ........... 6-6
7. Output Parameters – Required ............................................................... 7-1
7.1
Introduction ................................................................................................... 7-1
7.2
Specifying the Output Type............................................................................ 7-3
7.3
Choosing the Output Action for On/Off Control............................................... 7-4
7.4
Configuring Output Parameters for PID Control ............................................. 7-5
7.4.1
Choosing the Output Action for PID Control ............................................ 7-5
7.4.2
Specifying the Cycle Time for PID Control............................................... 7-6
7.4.3
Specify the PID Output Range ................................................................ 7-7
7.5
Configuring Output Parameters for Alarm Annunciation – 1ZC and 16C Only. 7-9
7.5.1
Choosing the Alarm Action...................................................................... 7-9
7.5.2
Choosing the Alarm Operation .............................................................. 7-10
7.5.3
Specifying the Alarm Delay – Optional .................................................. 7-11
7.5.4
Inhibiting the Alarm– Optional ............................................................... 7-11
7.5.5
Specifying the Alarm Value (Setpoint) ................................................... 7-12
900M050U00
 Athena Controls, Inc.
iii