Download Press - Daikin

English
ON TIMER Operation
„ To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time. ►Page 10
1. Press
.
•“
•“
•“
” is displayed on the LCD.
” blinks.
” and day of the week disappear from the LCD.
2. Press
until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the time setting rapidly.
3. Press
again.
•“
” and setting time are displayed on the LCD.
• The OPERATION lamp blinks and the TIMER lamp lights yellow. ►Page 5
Display
„ To cancel ON TIMER operation
Press
•“
•“
.
” and setting time disappear from the LCD.
” and day of the week are displayed on the LCD.
„ To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
„ In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
20
01_EN_3P276869-1A.indb 20
8/8/2012 4:18:22 PM