1
Download Black Box V5.1 Troubleshooting guide
Transcript
EnDuraSpark Electronic Ignition Installation & Troubleshooting v5.1 Step 16: Position Timing Wheel If necessary, loosen the three set screws with the provided small Wheel Hub Allen wrench (part #4) so that the timing wheel can rotate on the hub. LED Turn on the motorcycle’s ignition. With the engine at TDC rotate the timing wheel clockwise as viewed from the front of the engine. As the wheel rotates, the LED on the trigger plate will turn ON when the “S” stamped on the wheel passes the trigger. It will extinguish when the “N” on the wheel passes the trigger. Rotate the wheel a few revolutions to see how this works. (If the LED doesn’t come on, the wheel may need to be pulled out of the hub 1 mm or so until it does light). Slowly rotate the wheel until the LED just turns off. Tighten the 3 set screws. Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 www.EuroMotoElectrics.com [email protected] EDL-IGN Page 20 of 43 Tel: 1-303-526-0901
