Download Wayne SYLT30 Operating instructions

Operating Instructions and Parts Manual
Assembly
3.
4.
5.
(continued)
Place pump assembly inside tank,
keeping float away from the walls of
the tank.
Run power cord and switch cord
through holes in the power cord seal.
Insert seals into the holes in the lid as
shown in Figure 2.
Installation
Tools Required for Installation (not
included): PVC Glue, 7/16 in. wrench and
a screwdriver.
P VC
1. Connect discharge pipe (See Figure 4)
on Laundry Tray System to an existing
drain. Make sure all connections are
sealed.
2. Insert 1-1/2 in. Schedule 40 PVC pipe
into vent opening on top of Laundry
Tray System (See Figure 4). Insert pipe
2 to 3 inches into vent opening.
Support pump and
piping when
assembling and after installation. Failure
to do so could cause piping to break,
pump to fail, etc. which could result in
property damage and/or personal injury.
4. Protect electrical cord from sharp
objects, hot surfaces, oils, and
chemicals. Avoid kinking the cord and
replace damaged cords immediately.
NOTE: Make sure there is adequate room
for the float switch to move freely for
operation.
This pump is NOT
designed for use in
septic tanks or underground vaults to
handle raw sewage or effluents. NEVER
use this unit in hazardous or explosive
locations.
3. Connect Intake of this Laundry Tray
System (See Figure 4) to your washing
machine or other source. The threads
are 1-1/2 in. NPT.
Figure 2: Attach Seals to Tank Lid
6.
7.
8.
9.
Lubricate discharge pipe and seal
with soapy water.
Slide the lid (while holding the
discharge seal in place) over the
discharge pipe.
Line up the holes in the lid with the
threads in the tank.
Secure lid to tank using the screws
and washers provided. (See Figure 3)
Hand tighten all screws and then fully
tighten with a 7/16 in. wrench. Do
not over-tighten.
Ventilation
GFCI
Outlet
Discharge
Water
Inlet
Check Valve
Keep float free of
obstruction
Place the system
on a flat surface
Figure 3: Attach Seals to Tank Lid
Figure 4: Installation
www.waynepumps.com
2