1
Download A.O. Smith FPSH - 75 Technical information
Transcript
RESIDENTIAL GAS AND ELECTRIC WATER HEATER SERVICE HANDBOOK The information contained in this handbook is designed to answer commonly faced situations encountered in the operation of the Residential Gas and Electric product line and is not meant to be all-inclusive. If you are experiencing a problem not covered in this handbook, please contact the A.O. Smith Technical Information Center at 1-800-527-1953 or your local A.O. Smith Water Products Company representative for further assistance. Additional information is also available on the web site www.aosmithwaterheaters.com. This handbook is intended for use by licensed plumbing professionals and reference should be made to the instructional manual accompanying the product. This handbook contains supplemental information to the Residential Gas and Electric instructional manual. Qualifications Tools Required: • • • • • • • • • • • • For servicing gas models: Cross top screw driver 3/8, 7/16, ¾ inch open end wrenches 3/16 inch Allen wrench 11/16 inch – 6 point – socket – for anode removal set of marked drill bits electrical multimeter gas pressure gauge or monometer water pressure gauge thermometer tubing cutter if pilot tube is to be replaced hose – to drain tank container – to measure gallons per minute flow For servicing electric models: • 1 1/16 inch – 6 point – socket (for anode removal) • 1 ½ inch deep socket – to remove an element • electrical multimeter • water pressure gauge • thermometer • hose – to drain tank • container – to measure gallons per minute flow Rev 1 adds Technical Bulletins Rev 2 corrects illustration errors Rev 3 adds FVIR (C3) Technology product information 2005 printing – revised cover A.O. Smith Water Products Company ©2005 2 Technical Training Department Ashland City, TN
