Download Cabletron Systems SmartSTACK ELH100-12TX User guide

TFTP Download Menu
Use the TFTP Download menu to load software updates into the hub over
the network. The download file should be an ELH100-12/24TX binary file
from Cabletron; otherwise, the agent module will not accept it. The
success of the download operation depends on the accessibility of the
TFTP server and the quality of the network connection. After downloading
new software, the agent module will automatically restart itself.
Parameters shown on this screen are indicated in the following figure and
table.
Figure 3-14. TFTP Download Menu
TFTP Download
=============
Download Server IP:
10.1.4.45
Download Mode:
Upgrade DRAM and reboot
Filename: cbt0209b.bin
<Start TFTP Download>
<APPLY>
<OK>
<CANCEL>
Enter the server's IP address
Use <TAB> or cursor keys to move, <SPACE> to toggle, <ENTER> to select
Selection
Description
Download Server IP
IP address of a TFTP server.
Download Mode
You can download to permanent flash ROM or temporary
storage in RAM (for test purposes). However, if you
download to temporary memory, this firmware will be lost
upon power off.
Filename
The ELH100-12/24TX binary file to download.
Start TFTP Download
Issues request to TFTP server to download the specified file.
After the TFTP download is completed, the hub
takes approximately two minutes to restart. There is
no apparent activity during this time. You should
wait until the restart has completed.
44 ELH100-12/24TX User Interface
ELH100-12/24TX