Download Char-Broil 10101550 Product guide

ASSEMBLY
Tools required for assembly:
Phillips Screwdriver (Not Supplied); Small Adjustable Wrench (Not Supplied)
1
• Carefully turn the unit upside down.
• Slide Heatshield into place over the exposed burner tube.
Align hole in
Heat Shield
with end of
Burner Tube
Heat Shield in Position
2
• While holding the Heat Shield in place, slide the Control Panel Assembly into place, taking care to ensure that
the valve engages the burner tube. shown Figure A
• Install two #10x3/8" self-tap screws through the right side of the control panel. Leave screws loose.
• Make sure valve is inside burner tube. Align the heat shield as shown Figure B.
Secure control panel using the two remaining #10x3/8” self-tap screws. Tighten all four screws.
Fig. A
Burner
Tube
Valve
End
Qty: 4
#10x3/8"
Self-Tap Screw
Carefully insert valve end into burner tube making sure valve is centered with burner tube,
after aligned correctly, loosely secure with two self-tap screws on RH side of control panel.
Hold Heat Shield in place while attaching Control Panel
Screw hole
for leg - used
later.
Ignitor Wire
Proper Valve to Burner Tube installation
(veiw from underneath control panel)
Screw hole
for leg - used
later.
Fig. B
NOTE:
Install these
screws first!
Heat shield
Control
Panel
NOTE:
Ensure that the valve engages the burner tube
Page 13